PP Ningbo Jinfa T30S

PP Ningbo Jinfa T30S Resin

Material Introduction: PP Ningbo Jinfa T30S is widely‑used low‑MFR drawing‑grade homopolymer polypropylene, also frequently used for injection molding.

Main Applications

Food packaging: Non‑toxic, tasteless and odor‑free, complying with food‑contact standards including GB 9693‑88 and US FDA. Suitable for food containers, pharmaceutical packaging and other direct‑food‑contact applications.

Woven products: Traditional and primary application, including woven bags, tarpaulins, FIBC bulk bags, carpet backing, artificial turf, strapping ropes and packaging ropes. Good tensile strength and low elongation satisfy these working conditions.

Injection‑molded products: Daily‑use articles and general‑purpose components such as buckets, basins, stools, toys and household goods. Good flow property adapts to injection‑molding processing.

Films & fibers: Applied for tear‑film, monofilaments and spinning fibers.

Performance Parameters

Performance Category	Test Item	Typical Value	Test Condition / Reference Standard	Remarks & Interpretation
Physical Properties	Density	0.90‑0.91 g/cm³	Typical PP value	Low‑MFR drawing‑grade homopolymer PP
	Melt Flow Rate(MFR)	2.0‑4.0 g/10min	230℃/2.16kg, GB/T 3682	‑
	Isotactic Index	≥96.0 %	GB/T 2412	‑
Mechanical Properties	Tensile Yield Strength	28‑35 MPa	GB/T 1040	‑
	Flexural Modulus	1280‑1550 MPa	GB/T 9341	‑
	Izod Notched Impact Strength	~55 J/m (23℃)	‑	‑
	Rockwell Hardness(R scale)	90‑105 R	GB/T 9342	‑
Thermal Properties	Heat‑Distortion Temperature(HDT)	≥86 ℃ (0.45 MPa)	GB/T 1634	‑
	Vicat Softening Temperature	≥150 ℃	GB/T 1633	‑
Other Properties	Ash Content	≤0.04 %	GB/T 9345	‑

Processing Parameters

Processing Item	Reference Range	Remarks & Instructions
Drying Treatment	Normally not required	PP water absorption approx.0.01%‑0.04%. Drying is unnecessary under proper storage. Dry at 80‑100 ℃ for 1‑2 h if material gets damp.

Disclaimer: All above data is for reference only。